I hope that Panda Support answers my email, I noted on Amazon that they were active in answered Reviewers questions on other adapters.However if you think your question is a bit stupid, then this is the right place for you to post it.
Please stick to easy to-the-point questions that you feel people can answer fast. For long and complicated questions prefer the other forums within the support section. Now, that I have the 4.4.109 kernel installed, I am going to use your instructions to install the PAU06 in that kernel. I much appreciate your efforts, and future readers can also benefit from your post. I just tried that command: johnjohn-TP500LA rfkill list 0: phy0: Wireless LAN Soft blocked: no Hard blocked: no 1: hci0: Bluetooth Soft blocked: yes Hard blocked: no johnjohn-TP500LA and it is a great tool, thank you for the help. This adapter is used in a LOT of PCs, it is the MT7630E made by MediaTek Here is the link to where I found the instructions. Panda Wireless Pau06 Driver In LinuxHow to install Mediatek MT7630E wireless LAN driver in Linux MintUbuntu Mediatek launched a working driver for their wireless device MT7630E for Linux MintUbuntu which was officially supported only for kernel 3.13 and 3.14. The modified driver I am going to use can be installed upto kernel 4.4. Download: Download the driver from here (Its a modification of the original driver for easy installation) Install: Now follow the instructions below: 1. After installation has been completed the wifi will appear in the networkmanager and bluetooth will be available for use. The driver will load at startup automatically, so you dont need to load the driver every time you reboot. Congratulations I will post it anyway in case it helps someone else later. AZgl1500 wrote: None of them will recognize the Panda PAU06 adapter as a Plug n Play. ![]() The following was inspired by this Ask Ubuntu page. I tried a few things on my old MacBook running LM 18.3 Xfce 4.4.0-109. It has an internal wifi adapter. I plugged in a Panda PAU07. Having two adapters plugged in at the same time doesnt seem to be a problem because only one is active, I think (see more below). The terminal command rfkill list creates a list showing the index numbers of your wireless devices. In the above example, 0 is my internal adapter and 2 is my USB Panda. After issuing that command I lost wifi signal via the internal wifi adapter (index 0) as expected. To gain wifi signal via the external Panda adapter (index 2) I had to click on the wifi icon in the Notification Area of my panel and then select Enable Wi-Fi. This connection was automatic (i.e., no driver installation), but you do have to go through some network connections software of the Mint OS. I realize, that at this point, it is not nearly as serious for me as it was, but in the interests of being able to use it, I want it to work. I am thinking that file is created by the compiler to work with the specific PC that the code is running on. I found the file on a Cubic forum, but I doubt that it will work for me. I played with turn 0 off and back on, it is in Real Time, the instant RFKILL block 0 is issued, the Message popped up on screen saying Disconnected and unblock restored service immediately.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |